CORVON RID-A0 Remote ID Broadcast Module

The CORVON RID-A0 is an add-on Remote ID broadcast module. Stick it to the airframe and run one cable to the flight controller: the module takes the aircraft's identification and position from the flight controller and broadcasts them over Bluetooth. Works with ArduPilot and PX4 flight controllers.

- Add-on design: no flight-controller firmware or airframe changes; 3M adhesive and one GH1.25 cable
- DroneCAN over CAN or MAVLink over UART, with both cables in the box
- Broadcasting starts at power-on, no ground-station command needed
- Bluetooth 5 Long Range plus Bluetooth 4 broadcast
- Configure from a phone browser through the built-in Wi-Fi page; no app or driver
- One-time identity lock: the ID becomes read-only
- Signed OTA firmware updates
- 11.2 g in a 38 × 23.5 × 9 mm CNC aluminum enclosure

Choose the US or EU variant: the broadcast mode is preset at the factory to match.

Key specs:
Processor: ESP32-C3 (RISC-V, 160 MHz)
Wireless: Bluetooth 5.0 incl. Long Range (Coded PHY) · Wi-Fi 802.11 b/g/n (configuration only)
Band: 2.4 GHz (2402–2480 MHz)
Broadcast rate (factory default): Bluetooth 5 Long Range 2 Hz + Bluetooth 4 full message set 1 Hz
Interfaces: 2 × GH1.25 4-pin (CAN / UART) · USB-C · MMCX antenna port
Supply: 5 V
Serial number: ANSI/CTA-2063-A
Antenna: external RID-ANT-01, MMCX, 300 mm cable
Size & weight: 38 × 23.5 × 9 mm · 11.2 g (without antenna)
Compatible flight controllers: ArduPilot · PX4

In the box:
1× RID-A0 module
1× CAN cable
1× UART cable
1× RID-ANT-01 external antenna (300 mm cable, MMCX)

Full pinout, LED codes and antenna placement: see the spec sheet on this page.